40MPa Air Driven High Pressure Nitrogen Gas Booster System Oxygen Gas Booster System with 4L Tank

 Product DescriptionThe Terek gas booster equipment uses pure compressed air as the driving power source, and USES gas booster pump as the pressure source, Hydroge ,nitrogen, oxygen, helium,N2O,Argon, CO2 and other gases as the pressurized medium. The output pressure is proportional to the driving gas pressure.By adjusting the pressure of the driving gas source, the corresponding pressure of the pressurized gas can be obtained.When the pressure of the driving gas source is balanced with that of the pressurized gas, the pneumatic booster pump will be automatically stops and the output gas pressure is stabilized at the preset pressure. Therefore, it has the features of explosion-proof, energy saving, environmental protection, adjustable output pressure, small volume, light weight, simple operation, reliable performance and wide application range.To operate this system, The drive gas from the air compressor is required to start the Terek booster pump. The pressure of the drive gas can be adjusted by valves and pressure gauges, and the output gas pressure can be adjustedThe expected working pressure can be achieved by adjusting the pressure of the drive inlet.. When the driving air pressure and the output pressure are balance, the pump stops filling pressure and the output pressure remains at the preset value.TEREK gas booster pump uses compressed air to drive large area end piston to small area end to get high pressure gas output.. Can be used for compressed air and other gas, the output pressure can be adjusted by inlet valve, The output can ensure gas is not contaminated. Automatic pressure maintaining. Driven by gas, No spark or Flame and No generating heat, Can use it in dangerous places. Product parametersBasically the principle of operation is similar to a reciprocating amplifier where control of the piston at the end position is reciprocating , The automatic reciprocating motion of the piston is controlled by a built-in four-way valve. TEREK pumps are air driven at a drive air pressure of 3 to 8 bar (29 to 116 psi) by the normal air compressor.Refer to model technical parameters. ModelGU-GTB-30-STPressure ratio30:1Maximum gas outlet pressure320 bar / 4640 psiDrive air pressure range3-8 barWorking mediumNitrogen gas or other gasDrive mediumCompressed airWhen the driven air pressure is 3.8 barHigh pressure outlet pressure is 150 bar / 2175 psiWhen the driven air pressure is 4.3 barHigh pressure outlet pressure is 170 bar / 2465 psiMinimum gas inlet pressure10-15 barMaximum gas inlet pressure250 barValves and pipelinesHigh pressure needle valve and All stainless steel pipe.Pressure control accuracyless than 1%F.S;Pressure measurement accuracy gradeCL 1.6 Pressure gaugeDrive air inlet size12mm PU flexible pipeConnection size(inch) Gas inletNPT1/4  Internal threadConnection size(inch) Gas OutletNPT1/4  Internal threadSystem configuration: TEREK gas booster pump uses compressed air to drive large area end piston to small area end to get high pressure gas output.. Can be used for compressed air and other gas, the output pressure can be adjusted by inlet valve, The output can ensure gas is not contaminated. Automatic pressure maintaining. Driven by gas, No spark or Flame and No generating heat, Can use it in dangerous places.GU-GTB series gas booster unit control cabinet mainly includes one sets of GTB series air-driven gas booster pump, pressure gauges, air filter, gas inlet filter, control valves, air regulating valve, pipelines, cabinet, and pressure release valve etc.In order to ensure the long-term use and stable working efficiency of the equipment, we provide a set of sealing accessories, repair kit, sealing tape, etc . Detailed ImagesProduct advantages 1. All pipes and fittings are made of stainless steel to ensure a long life2. The pump will stop working automatically when the output pressure reaches the preset value,3. Maintain long working hours with no energy expenditure4.No dissipated heat during the pressure holding phase5.No risk for explosion and spark in oil and gas field6. The pump will start automatically when the outlet pressure drops slightly or the air drive pressure increases.7. The working pressure can be adjusted by adjusting the pressure of the driven air. 8.Easy to install, move, use and maintainApplication Fields1.Pressure test with gas2.Gas transfer and filling(Argon/Helium/Hydrogen/Oxygen/Nitrogen/CO2/NO2/CH4/LNG/LPG/CNG/FM200 etc.)3.Charging of gas cylinder and accumulator with nitrogen4.Supply for isolating gas systems5. High pressure gas injection system for various industries6.Transfer of oxygen cylinders7.Charging of breathing air bottles8.Leak test9.Hydrostatic Testing for valves, tanks, pressure vessels, pressure switches, hoses, pipes and tubing, pressure gauges, cylinders, transducers, well casings, gas bottles and air craft componentsPackaging & Shipping Our Services1. We'd like to provide our professional advice regarding machines, materials, packing and market for this p