High Purity 99.999% Industrial/Food Nitrogen Generator Professional Manufacturer

1. application of the cable industry:China is the world's largest cable producer, the world's first, $700 billion a year. The development of the cable industry is growing rapidly, and the supporting effect of the work economy is becoming more and more obvious.In the crosslinked cables, the main means of crosslinking are the non-inert gas (nitrogen) crosslinking, warm water crosslinking and irradiation, and the cable of large cross section and high voltage grade of 10, 000 kv, mainly the inert gas crosslinking (dry method chemical crosslinking). The inert gas crosslinking adopts polyethylene insulating materials that add peroxide, and through the three layers, the insulation layer of the conductor layer is completed by the layer of the insulation layer, the insulation layer of the insulation layer, and the continuous uniform through the sealing crosslinking process of high temperature and high pressure nitrogen through the insulation layer. The heat transfer media is nitrogen (inert gas), and the crosslink polyethylene electrical performance is excellent and the production range can reach 500kv.The survey shows that nitrogen conforms to the technical requirements of the gb3864 industrial use of nitrogen, which is used to heat the heating medium in the production of the joint cable, which can improve the quality of the products of the interconnection, the investment province and the high degree of automation. It requires 99.5 percent nitrogen purity. Nitrogen pressure 1.2~ 1.6mpa; The dew point is -40. In the past, most of the production lines produced by the production line were selected for the nitrogen, but because most of the bottled nitrogen was the parry of other manufacturers, most of the bottles were not pure enough, and the oxygen and water indexes were often excessive. If the medium water content is too high, the temperature is too high, the water vapor is produced, and the formation of bubbles in the plastic state of PE will make PE aging early. Therefore, the use of nitrogen gas sources required for the line of production line is critical.The method of using the method of varying pressure adsorption (psa) is a simple process, which is simple, room temperature production, low energy consumption, high automation, easy to stop, low maintenance, and the characteristics of nitrogen purity of nitrogen, such as air control, is an efficient system of nitrogen nitrogen. In the special requirement of the production of the connected cable, the pressure of nitrogen is 1.2~ 1.6mpal, and the nitrogen is instantaneous in the gas, so the nt nitrogen machine is designed with a volume of 6m3as, and the pressure is 3.0mpa in the middle pressure tank, which is used to balance the gas fluctuations. According to the quantity of the user line and the production situation to configure the quantity of the medium pressure tank.The actual operation of the psa nitrogen technology device in the line of intercable lines shows that the technology is advanced, the degree of automation is high, the nitrogen demand of the line of the wire line is adjusted, the problem of the nitrogen self-production supply is solved, and the investment is quick, and the investment can be obtained in the next year or so. As a mature engineering technology, psa nitrogen technology is widely used in chemical, chemical, gold, food and other processes such as the protection, displacement and pressure of inert gas2. Application of the steel industry:The system is widely used in the furnace roof seal, blast furnace iron coal powder blowing, continuous casting, steel annealing, the stress, the aging, the hardening, the carbon, the nitrogen, the soft nitrogen, the vacuum quenching, the nitrogen base, the nitrogen base, the nitrogen source, the welding and the powder metallurgical sintering process the protection gas, and the cleaning, the dilution of the gas.The scientific nitrogen inert protection process has been proved to be an essential part of the heat treatment industry.Nitrogen yield: 0.5-3000nm3/hNitrogen purity: 99.5%; -99.9999%(non-oxygen content)Nitrogen gas dew point: -45-45-45-45-45-45-45-45-45-45-45@@The high purity nitrogen of 99.9999% of the pure purity of the compressed air is obtained directly from the compressed air.To run reliably, but to achieve unattended;A wider range of dew points: -45of -70is;Energy utility system, according to demand production;Multi-function monitoring system, traffic, purity, pressure and other running parameters online display, equipment failure alarm, maintenance automatic prompt;The whole set is designed for the box and is easy to install.The system is pre-factory pre-factory.It can be equipped with a photoelectric dew point instrument to monitor the full performance of nitrogen.3. Application of the chemical industry:In chemical production, the nitrogen seal is used to ensure safe production and flammable and explosive, toxic and harmful gases. Nitrogen is mainly used in the production process of system repl